Factory Pro FP-M-AC3005LB 3mm x 0.5t Light Blue Collar Set 10 pcs  [FP-M-AC3005LB]

Price:
AUD$3.93
Brand:
Factory Pro
Model:
FP-M-AC3005LB
Condition:
Brand New
Write a review

Adjust and Fine Tune with Factory Pro FP-M-AC3005LB Collars

These 3mm x 0.5t collars come in a set of 10 and are finished in light blue for easy recognition. They are built for small spacing tasks where consistent gaps matter in RC assemblies.

Common Application Areas

Use the collars on axle hubs, servo shafts, or steering linkages to refine alignment and reduce unwanted play. Their thin gauge is suited to incremental adjustments without bulk increase.

Fitment Advice

They fit most models that accept 3mm collars and are useful across on-road and off-road vehicles. Check the shaft fit and stack as needed to dial in your desired clearance.

What is the best way to check collar fit?

Slip a collar onto the shaft and rotate while checking for wobble. A snug but not forced fit indicates correct sizing.

Are these collars suitable for frequent disassembly?

Yes, they work well for parts that are adjusted regularly since no permanent bonding is required for routine tweaks.

Can these collars be used with bearings?

They can be used near bearing assemblies to set axial spacing, but take care not to overload the bearing race or change preload unintentionally.

Copyright © 2008-2025 rcjaz.com.au All rights reserved