HUDY 182010 Flywheel and Clutch Multi-tool - Off-road Favourite  [HSP-182010]

Fast Turnaround for Nitro Engine Service

The HUDY 182010 Flywheel/Clutch Multi-tool uses Swiss 7075 T6 aluminum with a hardcoat finish to resist workshop wear. It is compact and built to take regular handling while keeping contact points accurate.

Built-In Functions for Engine Tuning

This multi-tool brings together the key functions needed for nitro engine maintenance in a single compact unit:

• Flywheel Holder: Holds modern flywheels with 2-to-4 pin configurations firmly to allow safe tightening or removal of the flywheel nut.
• Clutch Gap Measurement: Enables quick clutch gap checks from 0.5mm to 0.8mm, covering the typical range for contemporary nitro cars.
• Clutchbell Holder: Intended for centrifugal-axial clutchbells fitted with threaded pinions, common on nitro touring vehicles.

Use Cases and Notes

Whether performing race day checks or routine upkeep, the tool works well for both on-road and off-road flywheels. Keep in mind the Pinion Gear Tool is not supplied, so have one ready if you need to remove or fit pinions.