HUDY 294148 Race-Grade Ultra-Light Pinion 48T/64  [HSP-294148]

HUDY 294148 - Aluminium ULTRA-LIGHT Pinion Gear - Hard Coated - 48T / 64
Price:
AUD$37.19
Brand:
HUDY
Model:
HSP-294148
Condition:
Brand New
Write a review

HUDY 294148 Race-Grade Aluminium Pinion

Designed for serious RC setups, the HUDY 294148 Aluminium Ultra-Light Pinion Gear pairs a 7075 T6 aluminium core with a durable hard coat. The result is a lightweight pinion that maintains strength for dependable power transfer in race and practice environments.

High Accuracy Tooth Profiles

Produced with refined gear-cutting processes, this pinion delivers consistent tooth geometry that reduces binding and vibration, helping the drivetrain run more smoothly under load.

Minimal Mass, Maximum Responsiveness

The ultra-light construction reduces the rotating mass on the motor shaft, improving acceleration response and throttle control without compromising the part's mechanical toughness.

Fast Identification for Pit Work

Laser-etched markings on each pinion make it quick to identify tooth count during gear changes, saving time between practice runs or heats.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What materials are used in the HUDY 294148?

The pinion is machined from 7075 T6 aluminium and finished with a hard coating to improve wear resistance.

Is special lubrication required for this pinion?

Normal gear lubrication practices apply; keep lubrication appropriate for your spur and pinion pairing and avoid over-application that attracts grit.

How do I check mesh when fitting the pinion?

Install the gear and rotate by hand to inspect contact across tooth faces, then adjust motor position until you achieve even, quiet engagement.

Will the hard coating change gear noise levels?

The coating is intended to reduce wear; noise is more influenced by mesh and tooth geometry, so correct setup is key.

Copyright © 2008-2025 rcjaz.com.au All rights reserved