HUDY 294253 Aluminium Pinion Gear 13T 32P Hard Coated (MODUL 0.8) - Off Road Favourite  [HSP-294253]

Price:
AUD$37.95
Brand:
HUDY
Model:
HSP-294253
Condition:
Brand New
Write a review

Sturdy Pinion for Track and Bashing

The HUDY 294253 Aluminium Pinion Gear suits pilots who need consistent tooth engagement and lightweight construction. With its hard-coated aluminium alloy and 13T 32P MODUL 0.8 configuration, it is aimed at both competitive tuning and everyday bashing.

Advantages of Hard-Coated Aluminium

Hard coating increases the gear surface toughness, helping resist chipping and abrasive wear from dirt and grit. The result is longer service life and steadier performance across sessions where conditions vary.

Optimised for MODUL 0.8 Installations

Matching the MODUL 0.8 standard, this pinion is made to mesh cleanly with compatible gears for efficient power transfer. It is a practical choice for builders who swap gears to change final drive or replace worn components.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Do I need special tools to fit this pinion?

Basic pinion installation tools like a small spanner, hex drivers and feeler gauges are usually sufficient; follow correct mesh procedure to avoid damage.

Is this pinion suitable for high power setups?

The hard coating helps with wear resistance, but ensure your motor and ESC setup are compatible with aluminium pinions and check mesh under load.

How often should I inspect the pinion?

Inspect teeth after every few runs or after any heavy impact; cleaning out debris and checking for burrs will extend the life of the gear.

Can I use this with carbon or steel spur gears?

Yes, it meshes with any MODUL 0.8 spur gear material, but monitor wear patterns when pairing aluminium pinions with harder spurs like steel.

Will the coating affect gear noise?

The coating can slightly alter surface finish, but proper mesh and alignment are the main factors for reducing gear noise.

Copyright © 2008-2025 rcjaz.com.au All rights reserved