HUDY 294262 Aluminium Pinion Gear 22T Hard Coated (MODUL 0.8) - Off Road Ready  [HSP-294262]

Price:
AUD$40.22
Brand:
HUDY
Model:
HSP-294262
Condition:
Brand New
Write a review

Rugged aluminium pinion from HUDY for consistent drive

The HUDY 294262 Aluminium Pinion Gear is built to handle regular club and bashing sessions. Its aluminium core with a hard coated finish helps resist wear while the 22 tooth count and MODUL 0.8 sizing provide repeatable mesh and predictable power transfer.

Benefits of a hard coated 22T pinion

This pinion reduces the pace of wear on the driven system and keeps tooth profiles stable under load. The 22T layout is a sensible option when you want a middle ground between punchy acceleration and usable top speed.

Simple installation for common gearboxes

Because it follows MODUL 0.8 standards, the HUDY 294262 is usually a plug and play replacement. Swap it into compatible setups to restore proper meshing or to test different gear ratios with confidence.

Specifications

  • Make: Aluminium
  • Tooth Count: 22T
  • Module: 0.8
  • Treatment: Hard Coated

For off road and general hobby running, the HUDY 294262 gives a good mix of durability and predictable engagement.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this pinion cope with aggressive driving styles?

The hard coating improves wear resistance, but extremely aggressive use will still stress aluminium teeth. Regular checks and spare pinions are recommended if you run hard.

Should I change my spur when fitting a new pinion?

If your spur shows wear or damage, replace it at the same time to ensure correct tooth contact and avoid premature failure of the new pinion.

How do I protect the pinion from grit and debris?

Use a sealed gearbox or fit dust shields where possible, and clean the gear area regularly to limit abrasive particles from accelerating wear.

Is any special tooling needed to install this pinion?

Basic tools like an Allen key and pinion holder are usually enough. Confirm shaft diameter and secure the set screw to factory torque recommendations.

Can I recoat or harden the gear further?

Further surface treatments are not recommended without manufacturer guidance, as they can alter tolerances and affect mesh. Use the supplied hard coated finish as intended.

Copyright © 2008-2025 rcjaz.com.au All rights reserved