Kyosho PNGS4832 32T-48P Steel Pinion Gear Off-Road Edition  [KY-PNGS4832]

Kyosho PNGS4832 - Steel Pinion Gear(32T-48P)
Price:
AUD$13.63
Brand:
Kyosho
Model:
KY-PNGS4832
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $11.78 each $3.70 or 14%
3+ $11.20 each $7.30 or 18%
Write a review

Robust Pinion Gear for Dependable Drive Response

The Kyosho PNGS4832 Steel Pinion Gear delivers a simple, robust solution for restoring drive response in RC vehicles. With 32 teeth and a 48-pitch specification, it supports clean tooth engagement for a consistent feel on throttle.

Compatibility Notes

Designed to work with many 1/10 scale platforms that accept 48-pitch pinions, this steel gear is a sensible spare for drivers who swap gearing often or run in tougher conditions.

Practical Installation Advice

Install the Kyosho PNGS4832 by aligning the motor and adjusting the mesh until there is light tooth contact without binding. Routine cleaning and checks after dusty runs will keep it functioning longer.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will changing to a 32T pinion alter my top speed or acceleration?

Changing tooth count affects final drive ratio; a larger tooth count can increase top speed but may reduce acceleration. Check your current setup before swapping.

What shaft sizes does this pinion fit?

Verify the motor shaft diameter in your model manual; the PNGS4832 fits common shaft sizes used with 48-pitch setups, but confirmation is recommended.

Any tips to reduce gear noise after fitting?

Ensure accurate mesh, use a small amount of suitable gear grease on the spur if applicable, and recheck alignment after the first runs to quiet rattles.

Copyright © 2008-2025 rcjaz.com.au All rights reserved