Serpent SRX2 Gen3 1.4mm Rear Antiroll Bar - Off-Road Inspired Tuning  [SER500746]

Serpent SER500746 Antiroll bar 1.4 Rear SRX2 Gen3
Price:
AUD$8.38
Brand:
Serpent
Model:
SER500746
Condition:
Brand New
Write a review

Track-Focused Rear Antiroll Bar from Serpent

The Serpent 1.4mm Rear Antiroll Bar gives the SRX2 Gen3 chassis added rigidity at the rear, helping to stabilise the car through fast bends. It is a compact upgrade for hobbyists wanting more predictable handling.

Why the 1.4mm Choice Helps

A 1.4mm section increases resistance to roll, delivering crisper corner transitions and reduced chassis lean. That change often leads to improved lap consistency when paired with appropriate damping.

Designed Around SRX2 Gen3 Geometry

This bar is made to integrate with SRX2 Gen3 mounting points so fitment is clean and setup changes remain minimal while allowing targeted tuning adjustments.

Does the part require extra hardware?

It typically uses existing sway mounting hardware from the SRX2 Gen3 kit, though check your kit list and replace any worn pins or bearings for best performance.

How does this affect overall setup work?

Expect to rebalance front and rear roll distribution; small incremental changes to the antiroll bar often require matching changes to shocks and camber settings.

Is this suitable for club racing?

Yes, it is suitable for club and regional racing where drivers want a firmer rear end and more consistent corner exits on the SRX2 Gen3 chassis.

Copyright © 2008-2025 rcjaz.com.au All rights reserved