Serpent 6579 38mm Centax Flywheel - Competition Grade  [SER6579]

Serpent SER6579 Centax Flywheel 38mm
Price:
AUD$27.65
Brand:
Serpent
Model:
SER6579
Condition:
Brand New
Write a review

Fine-Tuned Centax Flywheel for Racing Setups

The Serpent 6579 Centax Flywheel, sized at 38mm, provides the rotational mass tuning racers expect for consistent engine behaviour. It is intended for 5mm chassis platforms and is compatible with the Serpent 950, Vector and Excel ranges, fitting Centax I and II configurations.

Surface Finish and Mechanical Fit

The component is hard anodized and topped with a PTFE coating to lower friction and resist wear during high rpm operation. The precise 38mm diameter ensures a secure fit within the specified chassis confines, helping maintain dependable performance during competition.

Is this flywheel suitable for club and national level racing?

Yes, the Serpent 6579 is designed with durability and repeatable behaviour in mind, making it appropriate for both club meets and higher level events when used with the correct Centax parts.

Will the PTFE layer affect balance?

The PTFE finish is thin and applied after machining; it should not noticeably change balance but check for smooth spin after installation and rebalance if necessary.

Any special tools needed for fitting?

Installation follows standard Centax procedures. Basic hand tools used for flywheel and clutch work are sufficient, and correct torque on fasteners is recommended for secure fitment.

Copyright © 2008-2025 rcjaz.com.au All rights reserved