Tamiya 51370 05 Pinion Gear 32T SP-1370 - Track Tune Part  [51370]

Tamiya 51370 - 05 Pinion Gear(32T) SP-1370
Price:
AUD$8.71
Brand:
Tamiya
Model:
51370
Condition:
Brand New
Write a review

Details on the Tamiya 51370 05 Pinion Gear (32T)

The Tamiya 51370 - 05 Pinion Gear (32T) offers a reliable alloy option for hobbyists working on 1/10 on-road vehicles. This 32-tooth pinion helps you dial in gear ratios for different track demands while staying tough under regular use.

Compatibility and Performance

Built from a strong alloy, the 32T pinion is compatible with several Tamiya chassis and provides a predictable change in gearing. It is a good choice when aiming to tweak the balance between acceleration and top speed.

Best Practices for Fitting

Make sure the motor shaft is clean and straight before fitting to secure accurate mesh. Adjust the gap so teeth engage smoothly without excessive preload, and check grub screws for secure mounting after a few runs.

Is this 32T suitable for high RPM motors?

Yes, it can be used with high RPM motors if the shaft fits, but ensure proper mesh and cooling to avoid extra wear at high speeds.

How do I set gear mesh correctly?

Use a thin piece of paper between pinion and spur, tighten the pinion, then remove the paper to leave a small clearance. Recheck after a short run.

Are there upgrade options for this pinion?

Aftermarket pinions in different materials or tooth counts are available for further tuning, but verify compatibility with your spur and motor setup before switching.

Copyright © 2008-2025 rcjaz.com.au All rights reserved