Tamiya 53600 Aluminium Stabilizer End Set 4pcs OP-600 - Off-Road Handling Kit  [53600]

Tamiya 53600 - Aluminium Stabilizer End 4pcs OP-600
Price:
AUD$12.39
Brand:
Tamiya
Model:
53600
GTIN:
4950344536009
Condition:
Brand New
Write a review

Lightweight Aluminium Ends for Stable Handling

The Tamiya 53600 Aluminium Stabilizer End Set is a straightforward upgrade to improve your vehicle's stabiliser response. Swapping in these aluminium ends gives smoother adjuster motion compared to stock components.

Fitment and Practical Uses

This set fits a range of Tamiya models including TRF414M, TA04, and TB EVO. The lighter ends help reduce bind in the stabiliser linkage and are suitable for both on-road tuning and light off-road setups.

Installation Best Practices

Secure each stabiliser end firmly but avoid excessive torque that could gall the aluminium. Regular inspection and light lubrication at pivot points will extend service life and maintain handling gains.

Will these work on my TB EVO straight away?

They are specified for TB EVO among other Tamiya kits. Fitment is usually direct but double check thread pitch and link geometry if your car has aftermarket components.

Are aluminium ends more fragile than plastic?

Aluminium can resist deformation better than plastic but can scratch or dent under heavy impact. They offer consistent performance but inspect after crashes.

Do these need lubrication?

A light film of grease on moving contact points helps reduce noise and wear. Avoid heavy grease that attracts dust and grit.

Can I install them with existing ball ends?

In most cases yes. Ensure the existing ball ends seat properly and that the overall linkage length remains correct after fitting the aluminium ends.

Copyright © 2008-2025 rcjaz.com.au All rights reserved