Sanwa 107A53691A Top Shell Replacement for SRG HVS  [SW-107A53691A]

Sanwa 107A53691A Servo Upper Case for SRG/HVS
Price:
AUD$12.39
Brand:
Sanwa
Model:
SW-107A53691A
Condition:
Brand New
Write a review

Replacement Top Shell Sanwa 107A53691A

The Sanwa 107A53691A top shell is a no-nonsense spare made for owners of SRG and HVS servos who need a quick replacement. It is shaped to match the servo body so linkages and gears remain aligned after refit.

Compatibility Notes

This shell is built to fit Sanwa SRG and HVS lines and is useful to keep on hand as a service part. Its plain layout allows for fast removal and installation with minimal disassembly.

Installation Recommendations

Prior to installing the top shell, give the servo internals a brief clean to remove any particles. Seat the shell evenly and tighten screws in a criss-cross pattern where possible to maintain even pressure. Correct fitment reduces the chance of premature wear.

Can I use this shell on digital servos?

The shell is sized for Sanwa SRG and HVS models; whether a servo is analogue or digital is secondary to the physical fit, so confirm model compatibility first.

Should I lubricate moving parts during fitment?

Only use appropriate small amounts of recommended lubricant on gears if needed, and avoid getting grease on bearing surfaces that should stay dry.

Does fitting this shell need calibration?

After fitting, cycle the servo and check end points and neutral. No special calibration is required unless you notice positional errors.

Copyright © 2008-2025 rcjaz.com.au All rights reserved