1/10 Formula Aero Wing HUDY 293701 — Front wing, white finish  [HSP-293701]

Price:
AUD$25.98
Brand:
HUDY
Model:
HSP-293701
Condition:
Brand New
Write a review

1/10 formula front wing details

The HUDY 293701 front wing is an aftermarket component for 1/10 formula style RC cars, supplied in white as a replacement or baseline tuning piece. It alters airflow across the front to influence balance and steering response where the body accepts an independent wing.

Installation is simple for bodies with separate wing mounts: align and test-fit before final fixing, then secure with the body’s original hardware or compatible fasteners. If trimming is necessary, do so conservatively and verify there is no interference with steering or suspension travel.

For tuning purposes, adjust incidence and mounting height incrementally and record handling changes. Use consistent test runs to judge how each small change affects lap times and driver confidence on your chassis.

Specifications

  • Item 1/10 Formula Front Wing
  • Model Number 293701
  • Material Manufacturer did not specify
  • Compatibility 1/10 formula scale RC cars, intended for bodies designed to accept a separate front wing

A practical option for replacing a damaged wing or establishing a neutral aerodynamic baseline when testing front-end setup changes on 1/10 formula models.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this wing allowed for use in club competition events?

Rules vary by club; check event regulations before racing. Generally, aftermarket aero parts are acceptable if they do not exceed body or dimensional limits specified by organisers.

What mounting angle works best for high-speed tracks?

Lower incidence tends to reduce drag on fast straights while modest positive angle increases front bite into corners. Start with small angle steps and test on a representative track to identify trade-offs.

Are there reinforced mounts I can use for heavier impacts?

Aftermarket reinforcement plates and thicker screw washers can help protect mounting points. Consider using a backing plate inside the body to distribute loads from impacts.

How should I verify there is no steering interference after fitting?

With the wing loosely fastened, turn the steering lock to lock and cycle the suspension through travel to confirm full clearance. Only tighten fully once you are satisfied there is no contact at extremes.

Copyright © 2008-2026 rcjaz.com.au All rights reserved