1/18 Scale Li-Po Intellect IP-1600A2S-20C 7.4V 1600mAh 20C for Tuning  [IP-1600A2S-20C]

Intellect (IP-1600A2S-20C) - 7.4V 20C 1600mah Lipo Battery
Price:
AUD$24.80
Brand:
Intellect
Model:
IP-1600A2S-20C
Write a review

7.4V compact Li-Po tuned for handling and setup

This Intellect IP-1600A2S-20C 7.4V 1600mAh 20C Li-Po is a compact race-style battery intended for 1/18 scale electric R/C applications. The pack is supplied in a hard case and uses common balance and discharge connectors listed below. The following notes concentrate on how the pack affects handling, setup repeatability, and best practices during tuning.

Fit and connectors: the pack dimensions are 85 x 30 x 16 mm, so verify your chassis bay and mounting points before fitting. The balance lead is XH2.5 and the discharge plug is ABC(5102); confirm compatibility with your charger and ESC or plan to use an adapter harness. The pinned hard case helps secure the unit in tight-fit installations.

Influence on setup: on 1/18 cars the pack's mass and location alter the centre of gravity and roll characteristics, which in turn impact traction and cornering. Keep the same pack when comparing suspension or gearing changes to ensure data consistency; the 20C rating provides a steady discharge curve useful when dialing motor timing and gear ratios.

Specifications

  • Item Intellect IP-1600A2S-20C Li-Po Battery
  • Model Number IP-1600A2S-20C
  • Voltage 7.4V
  • Capacity 1600mAh
  • Discharge Rate 20C
  • Cell Type Lithium Polymers
  • Balance Connector XH2.5
  • Discharge Connector ABC(5102)
  • Pack Dimension 85 x 30 x 16 mm
  • Color Black
  • Case Type Hard case with pin

For racers focused on setup and repeatable test conditions, the Intellect IP-1600A2S-20C provides a compact, predictable power source that supports consistent tuning and straightforward mounting in 1/18 scale vehicles.

Treat the battery as part of the sprung mass; when you move damping or spring rates, note how fore/aft placement of this 85 x 30 x 16 mm pack shifts the balance and adjust accordingly for consistent traction.
The 20C continuous rating supplies a stable current profile that makes motor timing and gear ratio tests more repeatable without the volatility of very high C packs.
Consider trimming adjacent foam or repositioning wiring to avoid pressure on the hard case; check pin alignment on the case so it seats flat and does not stress the ABC(5102) discharge plug.
Use the same charged state and pack orientation for each test run, monitor cell voltage under load, and keep gearing and motor timing constant when comparing lap times.

Copyright © 2008-2026 rcjaz.com.au All rights reserved