1/32 Mini 4WD Rail Guard M4WD-49/PK Pink Anodized for Tamiya by 3Racing  [M4WD-49/PK]

Tamiya Mini 4WD Aluminum Rail Guard -Pink - 3RACING M4WD-49/PK
Price:
AUD$7.16
Brand:
3Racing
Model:
M4WD-49/PK
Condition:
Brand New
Write a review

3Racing M4WD-49/PK pink stabiliser rail guard for Mini 4WD

This aftermarket aluminium rail guard provides a low-profile stabiliser option for Tamiya Mini 4WD cars. The machined, anodised plate protects rail contact zones and offers a tidy mounting surface that helps limit wear on body and bumper interfaces.

Intended for standard Tamiya 1/32 chassis (Super-II, MA, MS, AR, FM-A, VS and similar layouts), the guard is a single accessory item so verify your chassis hole pattern and alignment before final fitting. The pink coating is decorative; inspect the machined mounting faces for flatness and correct spacing.

Fitting requires common hobby tools and small screws; consult the seller to confirm if fixings are included. The guard changes local mass only slightly, so take a conservative approach when combining it with other stabilisers or heavy rollers. Always test-fit with your body shell before trimming or drilling.

Which Tamiya Mini 4WD chassis are compatible?

Compatible with common Tamiya 1/32 chassis such as Super-II, MA, MS, AR, FM-A and VS, but always check hole spacing and mounting geometry for your specific model.

Is assembly hardware provided with the guard?

Hardware inclusion depends on the listing. Many sellers offer the guard alone, so you may need to use standard Mini 4WD screws, nuts or spacers to secure it.

Will the anodised finish scratch during racing?

The anodised surface resists wear but will show abrasion at contact points over time. Structural integrity is retained even if the colour finishes wear away locally.

Do I need to alter the chassis to fit?

Some chassis accept the guard using existing screw positions; others require slight drilling or spacer shims. Test-fit first to avoid unnecessary modifications.

Is this suitable for both display and track use?

Its clean machining and anodised appearance make it suitable for display builds, and it can also perform on track when correctly fitted and positioned.

Can it be used alongside other stabilisers?

Yes, provided there is enough space for clearances. Dry-fit all stabilisers, rollers and body mounts to ensure nothing interferes before final tightening.

Copyright © 2008-2026 rcjaz.com.au All rights reserved