EDS 160231 Suspension Arm Reamer 1/8" (3.175mm) 120mm  [EDS-160231]

EDS 160231 - ARM REAMER 1/8inch (3.175MM) X 120MM
Price:
AUD$14.35
Brand:
EDS
Model:
EDS-160231
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Get Consistent Fits with the EDS 160231

The EDS 160231 Arm Reamer is a practical tool for RC technicians and weekend racers who need precise suspension arm holes. The 1/8 inch (3.175mm) cutter and 120mm overall length offer controlled reaming for accurate component seating.

Engineered for Reliable Hole Sizing

Use this reamer to smooth and size holes for bushings and pivot balls, helping to eliminate play and improve steering consistency. Its simple form keeps setup and use straightforward.

Workshop Use and Maintenance

Operate the reamer with light, steady passes and inspect the arm frequently to avoid removing too much material. The EDS 160231 is suited to regular maintenance cycles and pre-race checks.

Can I use this on both front and rear arms?

Yes, standard suspension arms that accept 3.175mm pivots can be reamed front or rear, just ensure alignment during the cut.

How do I check tolerances after reaming?

Trial-fit bushings or pivot balls and rotate the assembly by hand to confirm smooth movement without excess play.

Is a power drill safe to use with this tool?

Hand operation is preferred for control; if using a drill, run at low speed and steady pressure to avoid grabbing.

Copyright © 2008-2025 rcjaz.com.au All rights reserved