This 18mm rod end adapter is an RC tie-rod accessory intended for narrow steering blocks using the FLA arm layout. It creates a compact mounting point between a turnbuckle or tie-rod and the steering block while keeping the narrow footprint required by many scale and race-oriented builds.
The component is intended to supply a repeatable pivot interface for steering linkages, helping to cut side-to-side play and keeping steering geometry stable under load. It is defined by size and intended application rather than a list of specific chassis fits, so ensure your steering block accepts an 18mm rod end adapter before fitting.
Installation notes: the adapter installs into the compatible steering block location for FLA arm configurations and is used with standard RC tie-rod assemblies. Verify thread engagement and linkage alignment during fitting to prevent binding, and check full steering sweep after installation.
Copyright © 2008-2026 rcjaz.com.au All rights reserved