200mm Sensor Lead for RP - Yokomo YOKRP-012  [YOKRP-012]

Maintain consistent sensor wiring

The Yokomo YOKRP-012 Racing Performer sensor wire provides a straightforward replacement or extension lead for RP-series sensor-equipped brushless systems. At 200mm the lead gives a repeatable, tidy length for routing between a sensor-equipped motor and an ESC or junction in touring, drift, or competition electric cars.

Use the cable when repeatability matters for setup and tuning, or to replace a damaged sensor lead. Keep it separated from battery and high-current motor wires to lower interference risk, secure it with ties or clips, and avoid sharp bends near soldered joints. Only reduce excess length once final placement is confirmed to preserve signal integrity.

Installation notes: route the lead along chassis channels where available, protect soldered joins with heat-shrink to prevent shorts, and verify connector orientation before final assembly. The wire is passive and will not affect electronic timing or motor parameters by itself, but reliable sensor wiring is key to accurate commutation in sensor-equipped brushless motors.