3RACING Hard Coated 48 Pitch 16T Pinion - 3RAC-PG4816  [3RAC-PG4816]

Reliable 3Racing 48 Pitch 16T Pinion for Tough Conditions

The 3Racing 48 Pitch Pinion Gear 16T uses 7075 aluminium and a hard coating to give a balance of reduced mass and improved surface wear protection. This makes it suitable for users who push their rigs on rough tracks or trails.

Practical Benefits of the 3Racing Pinion

Thanks to the 7075 aluminium core and hard-coated tooth faces, the pinion resists everyday wear while remaining light enough to avoid unnecessary rotational mass. That helps with throttle response and gear longevity.

Fitment and Compatibility

This pinion is compatible with standard 48 pitch gear trains. It works as a replacement or a tuning change, but confirm motor shaft fit and tooth count compatibility prior to fitting.

Simple Installation Checklist

Align the pinion with the spur gear to achieve an even mesh, then run a short break-in at low load to seat the teeth. Check for looseness and inspect the coating after initial sessions.