3RACING 4.8MM Ball Stud L=6 (10pcs) - 3RAC-BS4806/GR Upgrade Set  [3RAC-BS4806/GR]

3RACING 4.8MM Ball Stud L=6 ( 10pcs) - 3RAC-BS4806/GR
Price:
AUD$5.75
Brand:
3Racing
Model:
3RAC-BS4806/GR
Condition:
Brand New
Write a review

Swap-In Ball Studs from 3Racing

The 3Racing 4.8mm Ball Studs, length 6mm, are supplied in a pack of ten to cover repair jobs and small upgrades. They are an easy replacement part for worn pivot points to restore handling consistency.

Function and Advantages

These studs give a secure articulation point for suspension and steering links, helping to keep geometry stable through rides. Properly matched studs reduce slop and improve predictability on track or trail.

Fitment Advice for Your Model

Designed for wide compatibility, these studs suit many common RC platforms. Verify the socket diameter and available clearance before fitting to make sure the parts operate without binding.

Are these ball studs good for off-road use?

They are suitable for many off-road models, but ensure you have adequate protection from dirt and check them frequently for wear in rough conditions.

What maintenance do these require?

Inspect for play and corrosion regularly, replace any studs that show wear, and recheck tightness after the first run following installation.

Can I use these on vintage or custom models?

Yes, they can work on older or custom setups if the dimensions are compatible. Measure mounting points carefully to confirm fit.

Do they come with washers or nuts?

This pack contains the ten ball studs only. Use the correct fastening hardware from your model or purchase matching nuts and washers as required.

Copyright © 2008-2025 rcjaz.com.au All rights reserved