3RACING 3RAC-SG64118/V2 64 Pitch 118T Spur Gear - Track Ready  [3RAC-SG64118/V2]

3RACING 64 Pitch Spur Gear 118T Ver.2 - 3RAC-SG64118/V2
Price:
AUD$6.59
Brand:
3Racing
Model:
3RAC-SG64118/V2
Condition:
Brand New
Write a review

Accurate gearing with 3RACING 3RAC-SG64118/V2

For hobbyists focused on dependable drivetrain output, the 3RACING 3RAC-SG64118/V2 delivers steady gear ratios and practical value. It suits those wanting a reliable replacement or upgrade part for their 1/10 models.

Performance characteristics

The 118 tooth 64 pitch spur balances torque and speed, making it a versatile selection for both circuit and mixed-surface running. It encourages smooth torque transfer and consistent lap times when properly meshed.

Practical installation notes

Mounting the 3RACING 3RAC-SG64118/V2 is normally straightforward on compatible 1/10 drivetrains. Pay attention to pinion alignment, secure grub screws, and clear any plastic shavings after trimming to avoid binding.

Does this spur suit brushless motors?

Yes, the spur itself is compatible with brushless systems as long as the motor and pinion are matched to the 64 pitch specification and the vehicle's torque demands.

Are there any break-in steps recommended?

Run a few light-power sessions while checking mesh and temperature, then inspect the teeth and recheck grub screw torque to ensure a stable fit.

Will using a larger pinion damage the spur?

A larger pinion increases load on the spur and drivetrain; it will not necessarily cause damage if mesh is correct and components are rated for the added stress, but monitor temperatures and wear.

Copyright © 2008-2025 rcjaz.com.au All rights reserved