3RACING Aluminum Center Pulley Gear T18 - 3RAC-3PY/18 On-Road Upgrade  [3RAC-3PY/18]

3RACING Aluminum Center Pulley Gear T18 - 3RAC-3PY/18
Price:
AUD$11.39
Brand:
3Racing
Model:
3RAC-3PY/18
Condition:
Brand New
Write a review

Aluminium centre pulley built for consistent belt performance

The 3RACING Aluminum Center Pulley Gear T18 is a practical upgrade for people who service and tune 1/10 scale on-road cars. Its aluminium construction improves longevity compared with plastic components and supports steadier power delivery under load.

Suitable applications

This pulley is matched to typical 1/10 scale on-road drivetrains and is useful for drivers looking to reduce drivetrain wear and maintain smooth belt operation. It is a straightforward replacement part for regular maintenance cycles.

Best practice for fitting

Before fitting the 3RACING Aluminum Center Pulley Gear T18, clean contact surfaces and verify shaft straightness. After installation, adjust belt tension to the recommended setting and recheck after a short run to ensure no slippage or misalignment.

Will this improve durability over plastic parts?

Yes, aluminium resists wear and deformation better than many plastics, so it can extend the service life of the centre pulley in regular use.

Should I change gearing when using this pulley?

Changing the pulley alone rarely requires different gearing, but always verify gear mesh and belt alignment after installing any drivetrain part.

What routine checks keep this pulley working well?

Inspect for debris, check fastener torque, and monitor belt wear. Address any signs of rubbing or noise immediately to prevent further damage.

Copyright © 2008-2025 rcjaz.com.au All rights reserved