3RACING Auper D6 Aluminum Rear Upper Arm Bolt SAK-D6823A - Off-Road Essential  [SAK-D6823A]

Price:
AUD$7.49
Brand:
3Racing
Model:
SAK-D6823A
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Reliable rear upper arm bolt for Auper D6 rigs

For routine maintenance or a targeted upgrade, the 3RACING Auper D6 Aluminum Rear Upper Arm Bolt SAK-D6823A provides a dependable replacement. It is intended for Auper D6 chassis layouts and keeps rear geometry stable during rough runs.

Why model builders choose aluminium hardware

Aluminium fasteners give a useful strength to weight ratio and resist typical hobby crashes when used within design limits. The 3RACING SAK-D6823A offers that balance so cars stay nimble without sacrificing toughness.

Fitment and easy installation for Auper D6 cars

Parts that slot in without adjustments save workshop time. This bolt matches Auper D6 mountings for a direct swap, making it suitable for replacing damaged bolts or fitting as part of a refresh kit.

Is extra hardware needed to fit this bolt?

Most installs use the same nuts and washers from the original setup. Check threads and replace any worn fixings to ensure a secure assembly.

Will this change handling noticeably?

Switching to aluminium bolts typically yields subtle changes by reducing unsprung mass; handling stays familiar but may feel marginally crisper at the limit.

Any recommended checks after installation?

After fitting, check suspension travel and joint freeplay, then run a short test to confirm there are no binding points. Re-torque after the first session.

Copyright © 2008-2025 rcjaz.com.au All rights reserved