3Racing SAK-X21 Upgrade Axle Pin Holder for Sakura XI  [SAK-X21]

3RACING Sakura Zero Aluminium Axle Pin Holder for Sakura XI - SAK-X21
Price:
AUD$4.84
Brand:
3Racing
Model:
SAK-X21
Condition:
Brand New
Write a review

Stiffen Your Sakura XI Axle Mount

The 3Racing Sakura XI Aluminum Axle Pin Holder, model SAK-X21, replaces the factory pin location with a tougher aluminium bracket. This part is aimed at reducing axle movement and keeping steering inputs precise under load.

Race Oriented Durability

Compared with standard plastic mounts, the aluminium holder resists wear and deformation when pushed hard. That increased rigidity leads to more predictable handling and fewer surprises in competition.

Simple Swap In

SAK-X21 is machined to match Sakura XI mounting points so installation is a straightforward swap. Fit it with common RC hand tools and recheck wheel alignment after installation.

Will this require setup changes?

Most users only need a quick check of toe and camber after fitting. The firmer mount can slightly alter steering feel, so a short test run is advised.

What fasteners are required?

The SAK-X21 uses the same fastener pattern as the stock part, so existing screws are usually suitable. Replace worn screws when necessary for secure mounting.

Is it worth upgrading for casual running?

Even casual racers benefit from reduced wear and steadier handling. The aluminium pin holder is a good mid level upgrade for longevity.

Copyright © 2008-2025 rcjaz.com.au All rights reserved