KYOSHO FW05-R/FW05RR Front Lower Arm Pivot Pin 64-Ti FW05-RR003B by 3Racing  [FW05-RR003B]

Kyosho FW05-R /FW05RR 64-Ti Front Lower Suspension Pin - 3Racing FW05-RR003B
Price:
AUD$5.66
Brand:
3Racing
Model:
FW05-RR003B
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Front lower pivot pin for FW05 models

This is a front lower suspension pin made for KYOSHO FW05-R and FW05RR chassis and identified by part number FW05-RR003B.

The pin is the pivot point for the front lower arm, keeping the lower joint aligned and reducing unwanted play. Replacing an aged pin brings back sharper steering response and steadier suspension geometry without changing ride height or link settings.

Fitment advice: swap this pin in place of the stock unit on FW05-R/FW05RR platforms. Standard front-end disassembly is required; after fitting, inspect suspension travel and steering clearance through the full range of motion.

Setup impact: a quality 64-Ti replacement pin can tighten pivot tolerance and support consistent roll behaviour, making it useful for both routine maintenance and precision tuning sessions.

Will this change my suspension geometry?

Fitting a same-dimension pin should not change geometry if installed correctly; it reduces play at the pivot but does not alter arm length or mounting points.

Is this material stronger than stock?

The 64-Ti alloy is chosen for strength and wear resistance versus common steels used in stock pins, which helps maintain tighter pivot fit over time.

Any special installation tips?

Use correct removal tools, avoid forcing the new pin, and verify the arm and carrier move freely through the full suspension travel after fitting.

Copyright © 2008-2026 rcjaz.com.au All rights reserved