Tamiya TA05 Aluminium Rear Hub Carrier 0 Degree Upgrade - TA05-16/0/LB by 3Racing  [TA05-16/0/LB]

0 degree rear hub carrier for TA05 chassis

This aluminium rear hub carrier is a replacement hop-up for the Tamiya TA05 chassis set at 0 degree. Fabricated from aluminium with a light blue anodized finish, it is intended to swap in for plastic stock carriers where applicable, offering steadier rear stiffness and reliable wheel location behavior.

Fit and compatibility rely on the TA05-series mount pattern and original hardware; confirm your specific chassis variant before fitting. The carrier interfaces with the standard rear uprights and wheel hubs and preserves normal axle and bearing mounting to suit most 1/10 scale touring car suspension arrangements.

Fitment tips: retain the factory mounting screws where feasible and observe recommended aluminium torque values to prevent thread damage. Consider this part a change in stiffness and tolerance during tuning, and plan small rear toe or camber adjustments after installation. This product is specified for RC scale cars only.