3Racing SAK-D4813/V2/BK Rear Shock Tower Upgrade Aluminum for Sakura D4  [SAK-D4813/V2/BK]

3RACING Sakura D4 Aluminum Rear Shock Tower - SAK-D4813/V2/BK
Price:
AUD$24.58
Brand:
3Racing
Model:
SAK-D4813/V2/BK
Condition:
Brand New
Write a review

Stiffen the Rear End with a 3Racing Upgrade

The 3Racing Sakura D4 Aluminum Rear Shock Tower, model SAK-D4813/V2/BK, upgrades the rear mounting area to reduce flex and allow more consistent shock geometry. This aluminum component helps the car respond predictably during high speed direction changes and rough sections.

Why Fit an Aluminum Tower

Aluminum towers give firmer anchor points for shocks and reduce component wear under load. The 3Racing part allows more precise tweakability to suit varied surfaces from smooth carpet to rough outdoor layouts.

Installation Guide and Fitment

Fitment is straightforward using the Sakura D4 chassis' existing mount points. The tower is a straightforward replacement for split or worn stock parts and will work with standard shock setups for most tuning needs.

Does the tower need special screws or washers?

It installs with the original hardware in most cases; inspect supplied holes and use the correct length screws to avoid contact with internal components.

Will this improve cornering on rough tracks?

Yes, the reduced flex and improved shock alignment make the rear more stable over uneven surfaces, which helps maintain traction and predictability through corners.

Is anodising available or required?

The finished part resists corrosion and is ready to fit; anodising is not required for performance but can help with scratch resistance and appearance.

Should I re-tune shocks after fitting?

Small shock and spring adjustments are recommended after installing a stiffer tower to find the best balance and rebound response for your driving style.

Copyright © 2008-2025 rcjaz.com.au All rights reserved