3Racing SAK-F50A Front Graphite Shock Tower Stiffer for Sakura FF2014/V2 Track Edition  [SAK-F50A]

3RACING Sakura FF Front Graphite Shock Tower Stiffer for FF2014/V2 - SAK-F50A
Price:
AUD$11.40
Brand:
3Racing
Model:
SAK-F50A
Condition:
Brand New
Write a review

Front chassis reinforcement for Sakura FF racers

The 3Racing Sakura FF Front Graphite Shock Tower Stiffer, SAK-F50A, adds front-end rigidity to the Sakura FF2014/V2 chassis. Its graphite construction is chosen to stiffen the nose without adding unnecessary mass, aiding stability at speed.

Graphite advantages for RC components

Graphite is valued for its strength to weight ratio, making it a common upgrade for competitive builds. This stiffer lessens flex under braking and cornering loads, improving consistency lap after lap.

Compatibility with Sakura FF2014/V2

Specifically modelled for the Sakura FF2014/V2, the part aligns with original mounting points for a hassle free fit. Expect a direct performance lift once installed and dialled into your setup.

Does this affect ride height or camber settings?

The tower itself does not change ride height or camber, but the firmer front can change how the car sits under load, so recheck alignment after fitting.

Is installation difficult for new builders?

Installation is straightforward for anyone familiar with basic chassis work; follow standard torque practices and make small setup tweaks after fitting.

Can I use this part on a car I race on mixed surfaces?

It performs best on smooth or prepared surfaces where reduced flex improves precision, though it still helps control on varied track surfaces.

Any special care when storing graphite parts?

Store in a dry place and avoid heavy loads on stacked parts; inspect for hairline damage before reuse.

Copyright © 2008-2025 rcjaz.com.au All rights reserved