3Racing Sakura Mini MG SAK-MG33 Rear Graphite Shock Brace  [SAK-MG33]

3Racing Sakura Mini MG RC CAR Graphite Rear Shock Tower - SAK-MG33
Price:
AUD$18.91
Brand:
3Racing
Model:
SAK-MG33
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Graphite rear brace for improved handling

The 3Racing Sakura Mini MG Graphite Rear Shock Tower SAK-MG33 strengthens the rear bulkhead to deliver more predictable handling. By using graphite, the part reduces unwanted flex and helps drivers keep a consistent setup across sessions.

Improved durability for regular use

This graphite shock tower holds up better under repeated impacts and hard landings than many stock components. That durability reduces downtime and keeps your car performing reliably over many runs.

Simple swap for Sakura Mini MG owners

SAK-MG33 is dimensioned to match the Sakura Mini MG rear mount geometry for a straightforward replacement. The precise fit reduces setup fuss and keeps the rear suspension geometry as intended.

Do I need special tools to fit the tower?

A basic hex driver set and a small screwdriver are usually sufficient for installation; no specialised tools are required for a standard swap.

Is graphite safer than aluminium for this part?

Graphite offers a balance of stiffness and controlled failure; it is lighter than aluminium and can absorb impact differently, which some drivers prefer for predictable break points.

Should I change shock oil after fitting?

Not required, but if the tower changes chassis behaviour you may fine tune shock oil or spring rates to restore your preferred handling balance.

Copyright © 2008-2025 rcjaz.com.au All rights reserved