42mm Titanium Turnbuckles for 1/10 by Yokomo YOKZCTB42  [YOKZCTB42]

Lightweight 42mm titanium turnbuckles

These aftermarket 42mm turnbuckles are intended for R/C tie-rod and suspension link uses where a 42mm length is needed. Supplied as a pair, the components are turned from titanium to help lower mass and resist corrosion compared to heavier stock metals.

Fitting is straightforward for experienced builders: remove the old linkage, hand-start the threads to prevent cross-threading, fine-tune the overall length to influence toe or camber, then secure rod ends using an appropriate thread-locking method for your model. Avoid over-tightening to protect threads and ball stud seating.

Small changes at the turnbuckle produce immediate shifts in steering and suspension geometry. Choose these titanium turnbuckles when durability and repeatable adjustment are priorities during setup for 1/10 scale touring cars or buggies, and always confirm full range of motion to prevent interference.