AE86 Levin Drift Body Decal Upgrade for D1 Spec - YOKSD86LD by Yokomo  [YOKSD86LD]

Yokomo SD-86LD - Decal Set For AE86 Levin Hayashi Wataru D1 Spec
Price:
AUD$43.99
Brand:
Yokomo
Model:
YOKSD86LD
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Visual detailing for drift setups

This decal set is an RC-scale detailing solution for AE86 Levin touring and drift bodies styled to the Hayashi Wataru D1 specification. The kit supplies pre-printed decals sized for 1:10 lexan shells and is offered as an aftermarket accessory for radio-controlled cars.

Sheets are printed on decal film and require trimming to match body lines. Recommended practice is to clean and dry-fit the decals, cut openings and mount holes first, then apply the decals and smooth them to remove air pockets. Use a sharp hobby knife for precision cuts around wheel arches and mounts.

The decals enhance the car's visual presence during events and aid in consistent body appearance for runs and displays. They work with painted shells when tested beforehand; always trial on a spare panel to check finish compatibility.

Specifications

  • Item: Yokomo SD-86LD Decal Set
  • Material: decal film
  • Model Number: YOKSD86LD
  • Compatibility: AE86 Levin Hayashi Wataru D1 Spec

Compatibility

  • AE86 Levin Hayashi Wataru D1 Spec

For enthusiasts after accurate graphics that lift a car's on-track presentation, this decal pack reproduces the AE86 Levin D1 styling and is supplied for careful fitting to 1:10 touring and drift bodies.

Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will applying these decals change how the car handles?

Decals are cosmetic and very light; when applied correctly they do not materially affect weight distribution or handling of a 1:10 shell.

Can the graphics be layered over custom paint schemes?

Yes, but apply after final masking and clearcoat steps are complete and test adhesion on a spare piece first to ensure the decal bonds to your paint system.

Are there tips for aligning multi-part graphics?

Start with the largest panel as a reference, use low-tack tape to hold pieces in place while positioning, and work from center lines outward for the best alignment.

What should I do if a decal tears during fitting?

Small tears can sometimes be overlapped with a spare scrap of film; for visible damage, replace the panel section from another sheet to maintain a clean finish.

Copyright © 2008-2026 rcjaz.com.au All rights reserved