Aizu Project 2001-4 Micron Masking Tape 1.5mm x 5m - Detailer Edition  [AIZ-2001-4]

Aizu Project 2001-4 - Micron Masking Tape 1.5 mm x 5m
Price:
AUD$7.34
Brand:
Aizu Project
Model:
AIZ-2001-4
GTIN:
4528403000176
Condition:
Brand New
Available in warehouse
Write a review

Precision striping for model detail work

The Aizu Project 2001-4 Micron Masking Tape is a slim 1.5 mm tape on a 5 m roll made for detail-focused model painters. It helps you isolate paint zones and pull clean, narrow stripes on bodies and instrument panels.

Model-making benefits

Perfect for adding thin trim and masks on small surfaces, this tape minimises bleed and lets you control paint edges on complex shapes. It is suitable for use on shells, cockpits, and small trim pieces where accuracy counts.

Application and removal best practice

Prepare the area by removing dust and oil. Smooth the tape down with your finger or a burnishing tool, paint in thin coats, and peel back slowly at a low angle while the paint is partially set to avoid tearing or lifting.

Can I use this tape on vinyl and polycarbonate bodies?

Yes. It adheres to smooth vinyl and polycarbonate, but always clean the surface first. For polycarbonate, use light pressure and test a small area to confirm removal behavior.

Does the tape shrink or curl after application?

Under normal conditions it stays stable. Avoid stretching the tape when applying as this can cause lifting as it relaxes. Use short lengths over tight curves.

How should I store unused rolls?

Keep rolls in a cool, dry place away from direct sunlight to preserve adhesive strength and prevent edge contamination.

Will the tape damage delicate decals?

It is unlikely to harm properly applied decals, but if in doubt test on a spare decal first. Use minimal pressure when applying over thin decal film.

Copyright © 2008-2025 rcjaz.com.au All rights reserved