JAZRIDER JR-HAG-TX500-048 Washer Upgrade for Align T-Rex 500 [JR-HAG-TX500-048]

Price:

AUD$4.68

Brand:

JAZRIDER

Model:

JR-HAG-TX500-048

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - Align - Trex 500

Secure alignment for your Align T-Rex 500

For pilots maintaining or refreshing an Align T-Rex 500, the JAZRIDER JR-HAG-TX500-048 washers deliver consistent spacing to keep control linkages and rotor parts aligned. They are specified to resist compression under normal flight loads.

Why install JAZRIDER washers on the T-Rex 500

Installing JAZRIDER JR-HAG-TX500-048 washers helps reduce side play in shafts and keeps bearing loads distributed correctly, which can prolong component life and stabilise handling across flights.

Can I use these washers on older T-Rex 500 frames?

They are made for the Align T-Rex 500 geometry, but many pilot reports show fit on older frames that use the same shaft and hub dimensions. Check clearances first.

Are replacements sold individually?

This set is offered as a matched pack. For single part replacements, contact your supplier to confirm availability of individual pieces.

Will these affect trim settings?

Replacing worn washers can restore original geometry and may slightly change trim feel, so recheck tail and cyclic trim after installation.

Hot Brands