APC AP09045EP 9x4.5EP Reverse Thrust Propeller for Electric RC  [AP09045EP]

Electric pusher blade details

The APC AP09045EP 9x4.5EP propeller is a scale replacement blade intended specifically for electric pusher or reverse-thrust layouts. Sold as a single prop, it is a practical spare or upgrade for small electric craft with rear- or aft-mounted motors.

Mounting notes: match the prop bore to your shaft adapter or collet before fitting, and use a hobby balancer to check for even weight distribution. Secure with the correct nut or collet and confirm the rotation direction aligns with the intended thrust, then perform a careful low-throttle static check to confirm clearance and vibration are acceptable.

Performance and care: installation of this prop alters thrust characteristics, cruise RPM and acoustic output without swapping motor hardware. Regularly inspect for damage, rebalance after any repair, and replace a compromised blade to prevent extra load on motor bearings.

• Compatibility note: Intended for pusher/reverse electric model arrangements rather than specific model listings.
• Installation tips: Balance first, tighten to the recommended feel, and perform a follow-up check after the maiden run.
• Tuning advice: Switching to different pitch sizes changes static thrust and cruise RPM; keep an eye on motor temps when testing changes.