APC AP1004 Propeller 10x4 for RC Planes  [AP1004]

APC PROPELLER 10x4
Price:
AUD$6.37
Brand:
APC
Model:
AP1004
Condition:
Brand New
Write a review

Performance and installation notes

This APC AP1004 PROPELLER 10x4 is an RC-scale propeller intended for model aircraft, with its 10x4 size selected to match typical mounting and performance targets on small and medium electric setups.

The content focuses on correct fitment, safe installation practice, and how prop choice affects thrust and motor loading rather than promotional copy. Verify shaft diameter and spinner clearance before each flight session.

Installation notes: balance the propeller using a balancer, secure it with the proper nut or adapter for your motor, and ensure prop clearance to avoid contact with airframe parts during operation.

Tuning role: a 10x4 blade tends to boost static thrust while limiting top-end RPM compared with lower-pitch props, so swap props stepwise when changing climb or cruise behavior and monitor current draw.

How does a 10x4 change climb and top speed?

A 10x4 typically increases static thrust and improves climb at the cost of some top speed. Observe RPM and current changes when you switch from a higher-pitch or lower-diameter prop to understand the trade offs.

What is the safe process for swapping props when tuning?

Change one variable at a time, balance the new prop, and run a short throttle test while measuring current. This approach helps isolate the effect of the prop on performance and electrical load.

Should I change battery choice after fitting a 10x4?

Monitor current draw on initial flights; if the prop increases load significantly you may opt for a battery with higher discharge capability or adjust prop size to stay within safe limits.

Copyright © 2008-2026 rcjaz.com.au All rights reserved