APC AP1103 11x3 RC Propeller Performance Blade  [AP1103]

APC PROPELLER 11x3
Price:
AUD$6.79
Brand:
APC
Model:
AP1103
Condition:
Brand New
Write a review

11x3 Prop Details and Setup

The APC AP1103 11x3 propeller is an aftermarket replacement suited to electric scale models that accept the 11x3 dimension. It is intended to provide the diameter and pitch expected for motors and airframes specified to use that size.

Check hub bore and adapter compatibility before fitting; the correct adapter and secure retaining nut or collet are essential. Make sure there is adequate spinner and airframe clearance once mounted on your motor hub.

When tuning, use the 11x3 spec to estimate thrust and top speed tradeoffs, then fine tune ESC timing and throttle curves while monitoring motor current and temperature to achieve the best balance between performance and reliability.

Will this prop change my model's speed and climb?

An 11x3 blade shifts the thrust and top speed characteristics; expect a balance favoring moderate thrust and reasonable top-end. Verify current draw to ensure your ESC and battery handle the load.

How should I tune my setup for an 11x3 prop?

Start with standard ESC settings, then adjust throttle curves and timing while monitoring temps and amp draw. Balance the prop and trim motor mounting if vibration appears.

Any tips to reduce vibration with this prop?

Ensure the APC AP1103 is precisely balanced, confirm straight mounting on the shaft and that the hub is free of burrs. Small imbalances should be corrected with tape or balancing compound.

Copyright © 2008-2026 rcjaz.com.au All rights reserved