ARC A11 Rear Lower Arm for Tuning and Repair - O-ARCP11R by Factory Pro  [FP-O-ARCP11R]

Price:
AUD$15.68
Brand:
Factory Pro
Model:
FP-O-ARCP11R
Condition:
Brand New
Write a review

Rear lower suspension arm tailored to ARC A11

Supplied as one piece, this rear lower suspension arm fits 1/10-scale touring cars and is listed as Factory Pro O-ARCP11R. It is manufactured for compatibility with the ARC A11 chassis to replace damaged parts or to alter the rear suspension setup.

The arm is suitable when replacing broken links, evaluating geometry changes, or swapping components to refine handling. By locating the rear hub relative to the chassis, it impacts toe settings, loaded camber, and roll center characteristics; consider these handling effects when adjusting rear stack components.

Fitting advice: check mount holes and ensure correct orientation before tightening bolts, inspect surrounding hardware for wear, and perform a wheel alignment check after installation. Sold as a single 1pc unit; confirm your ARC A11 configuration before fitting.

How will this affect handling?

Changing the lower arm can shift toe and camber behavior under load and alter the roll center, so expect measurable differences in corner entry and mid-corner balance.

Is this arm durable for track use?

The arm is designed as a replacement component for routine use; inspect it after impacts and replace if damaged to maintain predictable handling.

What should I check after fitting?

Verify correct orientation, torque settings, condition of ball studs, and rear wheel alignment following installation to ensure safe operation.

Copyright © 2008-2026 rcjaz.com.au All rights reserved