ARRMA Talion 6S EXB Replacement Center Front (116mm) and Rear (180mm) CVD Drives MTV6037S by GPM  [MTV6037S]

This replacement CVD driveshaft kit is produced for ARRMA Talion 6S EXB platforms, using hardened 4140 steel to increase torsional strength and surface durability. Components are machined to preserve original geometry for simple installation of center front and center rear drive parts.

Measured kit contents note a 116mm center front CVD and a 180mm center rear CVD, with a pin thickness of 3.0mm. The black hardened finish is applied to reduce wear and maintain stable joint contact surfaces.

The set is intended as a one-to-one replacement for the original parts, with manufacturer references AR310472+ARA-3398, keeping suspension and drivetrain dimensions intact on the Talion 6S EXB chassis.

Practical tuning tip: swapping to hardened 4140 CVDs reduces drivetrain deflection under heavy acceleration, helps maintain alignment between gearbox and diff outputs, and can extend life of mating cups if installed with correct clearance checks. Always confirm hub fit and full suspension articulation after installation.

Compatible Models

• ARRMA 1/7 Talion 6S EXB 4X4 RTR Brushless Speed Truck-ARA7707V6