Arrowmax AM-220026-G 6mm Bearing Trimmer 1/32 Mini 4WD Gray  [AM-220026-G]

Arrowmax AM-220026-G 6mm Bearing Trimmer For 1/32 Mini 4WD (Gray)
Price:
AUD$22.21
Brand:
Arrowmax
Model:
AM-220026-G
Condition:
Brand New
Write a review

Care and Trimming Tool by Arrowmax AM-220026-G

Arrowmax crafted this 6mm Bearing Trimmer for the detailed maintenance required by 1/32 Mini 4WD racers. The tool is intended to tidy bearing faces and remove tiny imperfections that cause resistance, and the gray finish keeps it understated yet practical.

How it Works

The trimmer lets you take off minimal material from bearing surfaces to improve roundness and alignment. That reduction in surface irregularity lowers friction and helps wheels turn with less drag, which is important in tight race environments.

Practical Tips for Racers

Use the trimmer as part of a consistent service routine: check bearings after practice and before races, perform conservative trimming, and re-evaluate wheel spin to gauge results.

Will this tool alter bearing tolerances?

When used correctly, trimming removes small surface blemishes without changing core tolerances. Only light passes are recommended to avoid excessive removal.

Is it suitable for sealed bearings?

Sealed bearings can be trimmed if you access the bearing surface safely. Be cautious with seals and check manufacturer guidance to avoid damaging seals or lubrication.

What should I check after trimming?

Spin the wheel on its axle to check for smoothness and listen for any irregular noise. Re-install and test on the track to confirm improved rolling behaviour.

Can trimming affect wheel alignment?

Proper trimming helps alignment by removing uneven bearing faces, but always re-check axle seating and spacer setup after trimming to ensure correct alignment.

Copyright © 2008-2025 rcjaz.com.au All rights reserved