Arrowmax AM-348034 48P 34T 7075 Hard Pinion Gear - Race and Trail  [AM-348034]

Arrowmax AM-348034 Pinion Gear 48P 34T 7075 Hard
Price:
AUD$8.58
Brand:
Arrowmax
Model:
AM-348034
Condition:
Brand New
Write a review

High-Strength Pinion Gear Overview

The Arrowmax AM-348034 pinion gear uses 7075 hard material to provide a durable option for RC enthusiasts focused on dependable drivetrain parts. This 48P 34T pinion helps deliver even power transfer and improved wear resistance in typical car applications.

Built for Reliability

Precision manufacturing and the use of 7075 hard material give the Arrowmax 48P 34T pinion its balance of strength and low weight. That makes it suitable for drivers who expect steady performance without adding excess mass to the drivetrain.

Compatible Setups

The pinion fits a wide selection of RC cars that run 48 pitch gears, so it is practical for pilots who change between different chassis or track surfaces. Its tooth profile supports standard on-road and off-road use cases.

Will changing pinion tooth count affect speed?

Altering the tooth count changes your final drive ratio. More teeth generally give higher top speed but less acceleration, while fewer teeth increase acceleration at the cost of top speed.

Is this a direct replacement for stock parts?

If your chassis accepts 48 pitch pinions and the shaft dimensions match, the Arrowmax AM-348034 can replace many stock pinions. Always verify shaft diameter and set screw type before fitting.

Any specific installation advice?

Ensure correct mesh by using a paper or feeler method, tighten set screws to recommended torque, and recheck mesh after a short run as components bed in.

Copyright © 2008-2025 rcjaz.com.au All rights reserved