Arrowmax AM-MTX-T2202E 26T 7075 Aluminium Pulley for Mugen MTX-5 - Race Ready Component  [AM-MTX-T2202E]

Arrowmax AM-MTX-T2202E Pulley 26T 7075 Hard
Price:
AUD$23.58
Brand:
Arrowmax
Model:
AM-MTX-T2202E
Condition:
Brand New
Write a review

Race-Grade 26T 7075 Pulley for Mugen MTX-5

Manufactured from high-strength 7075 aluminium, the Arrowmax AM-MTX-T2202E pulley is a race-focused replacement part for the Mugen MTX-5 chassis. It is intended to keep power transfer precise under hard use.

Strength Without Excess Mass

7075 aluminium gives a desirable balance of toughness and low weight, helping to reduce rotating inertia while standing up to track wear and impacts.

Accurate Tooth Profile for Smooth Delivery

The 26T configuration is machined for consistent meshing in the MTX-5 drivetrain, which supports cleaner throttle response and steadier acceleration through technical sections.

Will this pulley improve throttle response?

Better material and tighter tolerances reduce flex and slop, which can sharpen throttle feel compared to worn or plastic pulleys.

Is this suitable for off road tracks?

Yes. The 7075 construction holds up well to off road stresses, though you should clear debris regularly to avoid premature tooth wear.

What checks after installation are recommended?

Verify alignment, secure fasteners, and run the drivetrain at low speed to listen for binding. Recheck after the first session.

Can I use this with aftermarket gear sets?

Compatibility depends on gear pitch and spacing. Match tooth count and shaft dimensions; consult gear spec sheets before pairing.

Does the pulley need threadlocker on the set screw?

A small amount of medium strength threadlocker is recommended for kit screws that secure the pulley to prevent loosening from vibration.

Copyright © 2008-2025 rcjaz.com.au All rights reserved