Arrowmax AM-T3-303086 T3'12 Front 3.0MM Graphite Shock Tower - Vintage Xray T4  [AM-T3-303086]

Arrowmax AM-T3-303086 T3\'12 Shock Tower Front 3.0MM Graphite
Price:
AUD$18.66
Brand:
Arrowmax
Model:
AM-T3-303086
Condition:
Brand New
Write a review

Race-Grade Graphite Front Shock Mount

The Arrowmax AM-T3-303086 T3'12 Shock Tower is a front shock tower crafted from 3.0mm graphite for legacy Xray T4 models. It is a straightforward upgrade for enthusiasts maintaining older kits or seeking a firmer front end. Its lightweight, rigid makeup contributes to stable cornering and predictable handling.

Where It Fits

Made to match Xray T4 mounting points, this tower is intended as a direct replacement for worn or damaged pieces. The accurate hole pattern and thickness help keep suspension geometry correct for better track behaviour.

Mounting and Care

Tighten mounting screws evenly and avoid over-torquing to prevent stress. Periodic checks after sessions will identify any loosening or impact damage and help keep the car race-ready.

Is this suitable for foam track surfaces?

Yes, the added stiffness from the graphite helps maintain consistent steering on foam and carpet, reducing unwanted flex.

Will the 3.0mm thickness affect ride height?

Thickness changes are minimal compared with stock parts; you may need a small setup tweak, but overall geometry remains similar.

How do I check for wear in graphite parts?

Inspect for hairline fractures or delamination near screw holes, and replace if you spot any structural damage.

Copyright © 2008-2025 rcjaz.com.au All rights reserved