Associated RC 18T Upgrade Titanium Pivot Pins - TAR101 by GPM  [TAR101]

Lightweight titanium pivot pins for 18T

The TAR101 hinge pins are supplied as a set of four pairs for use on Associated RC 18T platforms. As direct replacements for factory pins, the titanium construction offers good strength-to-weight and improved corrosion resistance for small off-road models. The content outlines compatibility, straightforward fitting steps and how these pins influence suspension pivot play.

Application and purpose: These pins are designed to locate into the standard Associated RC 18T hubs and serve as the pivot axis for front or rear assemblies depending on vehicle configuration. They are commonly replaced as part of routine servicing and during setup work where stable pivot geometry aids predictable handling.

Fitting notes: Use normal hinge pin replacement practice. Clean pivot areas, remove retaining clips or e-clips and slide out the worn pins, checking the hub bores for wear before inserting the new pins. Refit the retainers and check that suspension moves freely through its travel. Only apply thread-lock to fasteners that require it; the pins do not need glue.

Practical setup advice

• Examine hub bores for wear before fitting to avoid reintroducing play.
• Light lubrication on mating surfaces helps prevent binding and corrosion.
• Confirm wheel alignment after changing pins, since small seating changes can affect toe and camber.