Auper D6 ARS Linkage Upgrade - SAK-D6808D/RE by 3Racing  [SAK-D6808D/RE]

Red Anodized ARS Mount for Auper D6

This red-anodized aluminum ARS linkage mount is supplied as a direct replacement for the Auper D6 plastic bracket and uses the chassis' existing linkage locations. The machined surface provides a stable face for link attachment and a cleaner mounting reference.

On track, the mount enables alternate ARS mounting positions so you can tune linkage geometry and roll response without major suspension changes. The aluminium piece supplies a stiffer reference for link ends, helping to preserve alignment under load and to produce consistent setup results.

To install, remove the stock mount, fit the aluminium unit in the same position, and fasten using the kit's original hardware. After installation, check link lengths and ball-end alignment at full droop and full bump to ensure free movement and correct preload.

Use advice: this spare is intended for 1/10 touring car chassis setup and handling refinement, suitable for hobbyists adjusting linkage settings on machines using the Auper D6 mounting standard.