Auper D6 Purple Rear Body Post SAK-D6820/PU Upgrade by 3Racing  [SAK-D6820/PU]

Rear body post for secure shell mounting

This is an RC-grade aluminum rear body post intended for the Auper D6 platform and sold as model SAK-D6820/PU. It is built to replace the rear body mounting point and maintain secure shell retention during handling and setup without modifying body geometry.

Design fitment is exclusive to Auper D6 body mounts as indicated, so check that your chassis shares the same rear post layout before installing. The purple finish is supplied to complement visual customization while remaining fully functional.

Installation is simple: remove the old post, position the replacement into the factory hole, and secure with the factory screws or compatible body clips; only standard hobby hex drivers and pliers are needed. Verify body alignment after fitment and trim the shell where necessary to recover clip clearance.

In setup scenarios the rear post provides a repeatable shell location and a robust anchor for rear clips when testing ride height or sway changes. It should be used as part of setup routines rather than assumed to change vehicle dynamics by itself.