Auper D6 Single Front Absorber SAK-D6807C/RE (Red) by 3Racing [SAK-D6807C/RE]

Price:

AUD$19.21

Brand:

3Racing

Model:

SAK-D6807C/RE

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Single front absorber — product summary

The component is an RC-scale front mono absorber sized for the Auper D6 chassis and supplied in a red anodized finish. It serves as a compact, serviceable single-tower upgrade for front suspension arrangements.

To install, remove the original front shock tower and bolt the mono absorber to the existing tower mounting points; common hand tools and a basic setup procedure are sufficient. There are no specialised tools included or required.

On the setup bench, spring selection, oil viscosity, and mounting placement are the primary levers to tune front grip, steering response, and transient behaviour. Make isolated changes and test over short runs to evaluate their effect.

Will I need to modify my shock tower for fitment?

Installation involves removing the stock tower; most Auper D6 towers will accept the mono absorber without cutting, but check hole alignment and spacing before installation.

Which adjustments most change handling?

Mounting position and spring rate produce the largest shifts in turn-in and mid-corner balance, while oil weight refines bump and rebound behaviour; change one item per test run to isolate effects.