Auper D6 Steering Fastener - Titanium SAK-D6805A by 3Racing  [SAK-D6805A]

Lightweight titanium fastener for the Auper D6

The SAK-D6805A steering rack bolt fits the Auper D6 chassis as a direct replacement for the original steering fastener. It secures the rack linkage and allows precise trimming of steering freeplay without changing alignment geometry.

Titanium construction reduces mass at the steering linkage and improves longevity compared to untreated steel hardware. The bolt is intended to work with the stock rack and linkage components, so no chassis modification should be necessary when installing.

Installation approach: remove the rack per the service guide, carry over any bearings or spacers, insert the SAK-D6805A and tighten to the recommended torque. Confirm full steering arc and make fine adjustments using the servo saver or turnbuckles to achieve the desired steering response.

Setup note: this bolt is useful when replacing worn hardware or when seeking a reliable upgrade that preserves steering feel and repeatable linkage position for setup consistency.