Awesomatix A12X Body Holder X - 2.0mm Graphite Setup Aid O-ACPP03 by Factory Pro  [FP-O-ACPP03]

Price:
AUD$17.43
Brand:
Factory Pro
Model:
FP-O-ACPP03
Condition:
Brand New
Write a review

Tuning-focused body holder for A12X

This Factory Pro produced-for accessory is an RC-scale body holder made specifically for the Awesomatix A12X chassis, supplied as one pair to secure the body on 1/10 electric touring machines. The use of 2.0mm graphite increases mounting stiffness while keeping the added mass minimal.

Role in setup: the holder X locks the polycarbonate shell to the A12X mounting points to make body position repeatable across setup changes and test runs. It is intended for mechanical positioning and consistency rather than to provide aerodynamic changes.

Setup advice: install the pair onto your existing A12X posts using stock hardware and confirm symmetrical seating before final tightening. After installation, evaluate handling under typical running conditions and use the holders to standardize body placement when testing suspension or ride-height tweaks.

Will these holders improve repeatability for setup comparisons?

Yes, the graphite holders reduce body movement and make it easier to compare changes between runs since the shell remounts in a more consistent position.

Do they affect aero balance or just mechanical fitment?

Their main job is mechanical positioning; any aerodynamic effect from slightly different body seating is incidental and not the primary design intent.

Any tips when tuning with these installed?

After fitting, re-establish baseline ride height and wheel clearance, then perform incremental setup changes—holders will help keep body position consistent so comparisons are more meaningful.

Copyright © 2008-2026 rcjaz.com.au All rights reserved