AX10 Scorpion 28mm Brushless Motor Mounting Plate AX10-16 by 3Racing  [AX10-16]

AXIAL AX10 Scorpion Chassis 28mm Brushless Motor Plate - 3RACING AX10-16
Price:
AUD$7.16
Brand:
3Racing
Model:
AX10-16
Condition:
Brand New
Write a review

Brushless motor plate for AX10 Scorpion

This aftermarket plate is intended for the AX10 Scorpion chassis and accepts 28mm brushless motors, offering a stable mounting surface to position the motor in relation to the spur and pinion so you can achieve repeatable gear mesh and secure installation.

Installation is a bench-fit routine: locate the motor, check pinion to spur engagement, then torque the fasteners. Confirm there is adequate clearance around the servo and ESC and use slight adjustments or shims to dial in mesh. Fit appropriate screws and ensure correct thread engagement with the chassis bosses.

When tuning, this plate lets you change motor offset and alignment without disturbing gearbox parts. Even small positional changes affect gear noise and heating, so validate mesh during short loaded runs rather than relying solely on a static check.

Will this accept common 28mm brushless motors?

Yes, it is designed to accept 28mm class brushless motors and align them with the AX10 Scorpion spur gear when mounted properly.

Should I expect to change the gearbox when fitting?

No gearbox modification is required; the plate provides motor positioning to achieve proper mesh without altering gearbox components.

How do I check mesh under load?

Run a short test at low throttle to let components seat, then re-inspect mesh and make small tweaks if you hear noise or see excessive backlash.

Copyright © 2008-2026 rcjaz.com.au All rights reserved