Axial AX10 Steering C Hub Carrier Upgrade for Deadbolt - AX10-24009-OR by Jazrider  [AX10-24009-OR]

Axial Racing AX10 Deadbolt Aluminum C Hub Carrier
Price:
AUD$14.81
Brand:
JAZRIDER
Model:
AX10-24009-OR
Condition:
Brand New
Write a review

Steering-Grade C Hub Carrier for AX10

This aluminum C hub carrier is an aftermarket replacement made for Axial AX10 Deadbolt chassis, providing a metal alternative to the original plastic carrier. It is engineered to keep the OEM mounting pattern and fit Deadbolt knuckle geometry so the chassis remains unchanged.

Installation notes: fit the carrier in place of the factory C hub using the existing wheel hex and axle arrangement common to AX10 Deadbolt models. Check that fasteners are the correct length and that pin alignment is correct before final torque; typical setup requires only standard hex drivers and a wheel stand for alignment work.

Tuning role: swapping in an aluminum carrier increases steering stiffness and stabilizes the pivot, giving crisper steering input and more consistent geometry when setting caster or toe. Racers and precision builders use this upgrade to reduce flex and improve steering feedback.

Will changing to this carrier affect caster or toe settings?

The carrier itself does not change geometry, but its increased stiffness makes adjustments more predictable since the pivot flex is reduced.

Does the weight of the part change handling feel?

Metal is heavier than plastic and can provide a more planted feel; however the primary handling benefit comes from reduced flex at the wheel pivot rather than mass alone.

Any setup tips after installation?

After fitting, recheck wheel alignment and steering centring. Small caster or toe tweaks may be needed to fine tune the firmer steering feedback.

Copyright © 2008-2026 rcjaz.com.au All rights reserved