AXIAL CAPRA 1.9 Brass front/rear gearbox protection and mass kit CP012AX by GPM  [CP012AX]

Brass front and rear gearbox covers for CAPRA 1.9 UNLIMITED

This aftermarket 5-piece brass gearbox cover set fits the AXIAL CAPRA 1.9 UNLIMITED chassis. Machined brass covers and supplied stainless steel cap head screws are intended to protect the gearbox faces and add rotational mass to help steady differential rotation during slow technical crawling.

The covers are manufactured from brass with an assembly weight of 67 grams listed in the source. That concentrated weight is useful as a tuning aid for traction and balance on scale trail rigs without altering internal gearing. Fitment is stated for AXIAL CAPRA 1.9 UNLIMITED only, so treat this as an upgrade accessory when planning suspension or driveline changes.

To install, remove the stock cover and either reuse or replace any seals. Fit the supplied 2.5x16 stainless cap head screws, tighten to typical small-scale RC torque, and check differential rotation by hand to confirm smooth mesh and correct bearing alignment.

Install this brass cover set to improve gearbox protection and add a modest weight bias for better low-speed diff stability on an AXIAL CAPRA 1.9 UNLIMITED. Verify screw torque and gear mesh after fitting and monitor performance on a short trail outing.